Answer:
Ummm wasn't me but thank you for the points hope you have a great holiday and new year!
Step-by-step explanation:
The steps to use to construct a frequency distribution table using sturge’s approximation is as below.
<h3>How to construct a frequency distribution table?</h3>
The steps to construct a frequency distribution table using Sturge's approximation are as follows;
Step 1: Find the range of the data: This is simply finding the difference between the largest and the smallest values.
Step 2; Take a decision on the approximate number of classes in which the given data are to be grouped. The formula for this is;
K = 1 + 3.322logN
where;
K= Number of classes
logN = Logarithm of the total number of observations.
Step 3; Determine the approximate class interval size: This is obtained by dividing the range of data by the number of classes and is denoted by h class interval size
Step 4; Locate the starting point: The lower class limit should take care of the smallest value in the raw data.
Step 5; Identify the remaining class boundaries: When you have gotten the lowest class boundary, then you can add the class interval size to the lower class boundary to get the upper class boundary.
Step 6; Distribute the data into respective classes:
Read more about frequency distribution table at; brainly.com/question/27820465
#SPJ1
N(2x+y) = x +1
Differentiate both sides, using the Chain Rule on the left side.
(1 / (2x + y)) * d(2x + y)/dx = 1
(1 / (2x + y)) * (2 + dy/dx) = 1
<span>Rearrange to isolate dy/dx.
</span>
Answer:
You already did the question.
Step-by-step explanation:
What's there to simplify?
5+7 = 5+7
It's just recursive.
Answer
Q1- c
Q2-c
Q3-d
Q4-b
Q5-a