Answer:
Wide Area Network or Public WAN
Explanation:
Answer:
Redundant paths can be available without causing logical Layer 2 loops.
Explanation:
- Spanning Tree Protocol is used to allow redundancy in the Layer 2 switched networks without creating cycles/circles also called loops.
- These loops are called physical loops.
- When two parts of the switched network are connected via two or more Layer 2 switches this result in a loop.
- This affects the performance of the network as the result of broadcast packets flooding.
- STP puts one port of the switch to forward mode and the rest of the ports within the same part of the network to the blocking mode to avoid broadcast packet flooding. STP puts all the ports that are allowing redundant paths to block mode and the one port that is left after this is placed in forward mode.
- Spanning Tree Algorithm is used by STP to determine the optimal path of switch to the network.
- Bridge Protocol Data Units are used to share the information about the optimal path determined by the spanning tree algorithm with other switches.
- This information helps STP to eliminate the redundant paths.
- So this is how STP tracks all the links in the switched network and eliminates redundant loops by allowing only one active path to the destination while blocking all other paths.
Answer:
C
Explanation:
As the unit is defined as integer type i.e. unit will have whole number, mass is defined as float data type which will have fractional values, and weight is defined as double data type which can have both values i.e. fractional value or integer value.
If you multiply an integer value by a fractional/decimal value it will give fractional value (unit value will promote to fractions).
Thus, result will be fractional value so result of unit*mass will be double.
IP config. Thats assuming its not just talking about the keys on your keyboard
Answer:
The explanation for the given question is described in the explanation section below.
Explanation:
An interrupt seems to be a mechanism whereby modules like I/O or storage will interrupt regular CPU processing. It may also be through pressing on a cursor, pushing a key, writing a document, etc.
There will be, essentially, three categories of interrupts such as:
- Software Interrupt.
- Internal Interrupt.
- External Interrupt.
The control circulates then shifts to a special application segment called Interrupt Provider or Try to disrupt management routine. The Interrupt handler will identify the interruption and restart the program. Statement swapping is the core feature of Interrupt Handling. This would be the method of processing and retrieving the CPU state.
If the management process has been finished, the operation of the program proceeds.