The two places you can control tab settings are the ruler and in the dialog box.
<h3>What are setting tabs?</h3>
The Ctrl + Tab is one that is often referred to as Control Tab and C-tab or the Ctrl+Tab.
It is known to be a keyboard shortcut that is said to be most often used to chose between open tabs in a browser.
Note that the settings Tabs are said to be a kind of paragraph-formatting tool that is often used to align text.
Hence, The two places you can control tab settings are the ruler and in the dialog box.
Learn more about control tab settings from
brainly.com/question/11509892
#SPJ1
See full question below
Where can’t you control tab settings? Check all the apply
On a ruler
In a dialog box
In the mini toolbar
In the paste special options
Answer:
a. PCI express
Explanation:
<em>PCI express</em> (Peripheral Component Interconnect Express) is a high speed serial bus and commonly used motherboard interface for Graphics card, wifi, SSDs and HDs hardware connections. Simple PCI can also be used but PCI express has more error detection accuracy lesser number of I/O pins and better throughput as compared to simple PCI.
Larry page is the correct answer :)
Answer:
B. Archery
Explanation:
the art, practice, or skill of shooting with bow and arrow
Answer:
B. Run-time Error
Explanation:
You can't divide by zero in math because it could be divided by itself an infinite number of time, which is not possible.
A. Syntax error is just the 'grammar' of the code. An example could be forgetting to add a semicolon at the end of your code in C. Another example is forgetting to close brackets or quotes
<em>printf("inclomplete string </em>WRONG, will give syntax error
B. Run-time error is an error that occurs while the program is running. This might happen because of many reasons, one of which is calculation errors such as dividing by 0.
C. I don't know what an Undetected Error is. Never hear of it.
D. Logic error is an error when a condition is not logically correct. This could be because you used the wrong type of operator.
if(a = b) WRONG, will give logic error
if(a == b) CORRECT
