Answer: Stands for "Instant Message." Instant messaging, or "IMing," as frequent users call it, has become a popular way to communicate over the Internet
Explanation:
Answer:
The description for the given question is described in the explanation section below.
Explanation:
Anyway, after getting acknowledgment from B, C and D will A immediately send a package here. So that we can establish a procedure whereby A must wait until all three acknowledgments are provided.
Start waiting for the specified scenario or situation:
⇒ For sender (sender is A here):
Keep the following steps repeated before all packets are shipped out.
- Step 1 : Place in the broadcast network a fresh packet and configure the wait bit= 1 and the ack bits= 000 and begin the timer (t=0). While bit allows while for the sender(A) to deliver the next packet. Ack parts will hold the earned acknowledgments until now. When first bit= 1 then ack obtained from B, if second bit= 1 then ack obtained from B and instead ack collected from D if the last bit= 1.
- Step 2 : Once sender(A) receives a new acknowledgment, change the ack bits through generating the resulting bit= 1.
- Step 3 : Test if bits of the ack = 111 otherwise render a bit of wait = 0. Go so far as to step 1 and proceed to step 2.
- Step 4 : Whether A has been waiting for t= t0 time and therefore not gotten at least one ack, then place a certain packet on the channel and make t=0, ack bits= 000 and start preparing bit= 1. Then move forward with step 2.
⇒ For receiver (receiver are B, C and C here):
- Step 1 : Wait for another package.
- Step 2 : On delivery of the new document, send ack to the provider and begin countdown t = 0.
- Step 3 : When no latest packet arrives in t= t0 time then give the existing packet acknowledgment again. As it indicates the channel ack may be missing.
- Step 4 : Taking a move to 1.
I rly don’t know bro buhh all Ik is there a lot of question
The only correct answer is C.
A allows decimal and non-decimal values.
B allows any string and you could put a decimal point value into it.
C only allows whole numbers.
D is the same as B just a bit more redundant.
Answer:
#include <stdio.h>
#include <string.h>
int main(void) {
char simonPattern[50];
char userPattern[50];
int userScore;
int i;
userScore = 0;
scanf("%s", simonPattern);
scanf("%s", userPattern);
for(i = 0;simonPattern[i]!='\0';i++){
if(simonPattern[i]!=userPattern[i]){
userScore=i;
break;
}
}
printf("userScore: %d\n", userScore);
return 0;
}
Explanation:
- Use a for loop that runs until it does not reach the end of simonPattern.
- Check whether the current index of simonPattern and userPattern are not equal and then assign the value of i variable to the userScore variable and break out of the loop.
- Finally display the user score.
