Answer:
UPDATE acctmanager WHERE amid = 'J500';
Explanation:
The statement written above is not valid SQL statement because there is no SET after UPDATE. Update is always used with SET.If you are updating something then you need to specify the value with which that value should be replaced.
UPDATE acctmanager SET amname = UPPER(amname);
This statement does not contains WHERE clause but it will run all the values of amname column will get updated in the table acctmanager.
Answer:
b. a variable
Explanation:
A variable holds a specific type of data
Answer:
A waveform that switches representing the two states of a Boolean value (0 and 1, or low and high, or false and true) is referred to as a digital signal or logic signal or binary signal when it is interpreted in terms of only two possible digits.
Answer:
1) Bottom-up
2) Top-down
Explanation:
In general dynamic programming is a divide and conquer strategy which can be implemented using bottom up approach or top down approach.
Bottom-up approach in dynamic programming will solve a relatively simple sub-problem first and then use the solution to build and arrive at solutions to a bigger sub-problem.
Top down approach is reversed to bottom-up approach and is also known as Memoization Method. Instead of solving a problem started from the base state sub-problem, the top down approach break a problem into a smaller problems from the top most destination state until it reaches the bottom most base state.
