I would tell said individual to stop what they’re trying to tell me because if it’s not stuff I should know about or want to hear about then I don’t wanna hear any of it
Go to a blank cell and type
=AVERAGE(A1:A10) then <ENTER>
As if by magic, the average of those cells
will appear where you typed the formula.
Answer:
a. 1 is a packet, 2 is data, 3 is a frame.
Explanation:
And what is not mentioned is segment which used TCP/UDP and is part of Transport layer. The packet carries the destination and sender IP address, and is part of the Network Layer. The frame has the Mac address of destination device and senders device and is part of data link layer.
Hence segment has no IP address, hence b. is not correct. Also, data cannot have the IP Address, and Frame has the MAC address, Hence, the above answer. And this arrangement is part of Data Encapsulation.
Also keep in mind data can be anything like a series of bits, or any and it can or not have a header.
Answer:
d. All of the above
Explanation:
Physical layer is the lowest layer of the OSI reference model that deals with the setup of physical connection to the network and with transmission and reception of signals.
Full duplex (FDx) is a bidirectional type of communication system where two end nodes send and receive data signals at the same time, and a single carrier is simultaneously used for dual communication.
To send or receive data, the participating nodes in a Full Duplex system do not have to wait for a free carrier/medium. It employs a medium that has at least two internal channels - one for sending and one for receiving.
Based on the above explanations, options A, B and C are valid and are correct ways to accomplish full-duplex (FDX) digital communications on guided medium at the physical layer (OSI Layer 1). There all of them are correct.
