Answer:
There is an error, the else should be after the elif
Explanation:
Answer:
#program in Python
#read until user Enter an integer
while True:
#try block to check integer
try:
#read input from user
inp = int(input("Enter an integer: "))
#print input
print("The integer is: ",inp)
break
#if input is not integer
except ValueError:
#print message
print("Wrong: try again.")
Explanation:
In try block, read input from user.If the input is not integer the print a message in except block.Read the input until user enter an integer. When user enter an integer then print the integer and break the loop.
Output:
Enter an integer: acs
Wrong: try again.
Enter an integer: 4a
Wrong: try again.
Enter an integer: 2.2
Wrong: try again.
Enter an integer: 12
The integer is: 12
Answer:
See Explanation Below
Explanation:
The new code segment is
int feb = 28;
if ((year % 4) == 0 && (year % 100) != 0) // assume that year is an integer with a valid year value
{
System.out.println("This is a leap year");
feb = 29;
}
Assume year = 2020, the assigned value of feb is 29;
Reason below;
At line 2 of the new code segment, two conditions are tested both of which must be satisfied.
1. year % 4 == 0
2020 % 4 = 0
0 = 0 (True)
2. year % 100 != 0
2020 % 100 != 0
20 != 0 (True)
Since both conditions are true, the value assigned to feb will be 29 and
"This is a leap year" will be printed without the quotes
Answer:
See attachment for flowchart
Explanation:
The flowchart is represented by the following algorithm:
1. Start
2. Input Mass
3. Input Volume
4 Density = Mass/Volume
5. Print Density
6. Stop
The flowchart is explained by the algorithm above.
It starts by accepting input for Mass
Then it accepts input for Volume
Step 4 of the flowchart/algorithm calculated the Density using the following formula: Density = Mass/Volume
Step 5 prints the calculated Density
The flowchart stops execution afterwards
Note that the flowchart assumes that the user input is of number type (integer, float, double, etc.)
