Answer: Worsening average temperature, precipitation fluctuations, drought conditions.
Answer:
superincumbent load in rock slab
Explanation:
- This pressure is defined as the geothermal pressure that the rocks excerpt from above the surface of the earth which is caused by the weighting of the overlying rock strata.
- This identification can be found in geology itself in terms of fluids and natural gases which led to the formation of coal deposits millions of years ago. With great pressure and thrust from the rocks
- This burning pressure that the rocks feel from above as in the case of earth core and mantle layers. A tectonic plate is subdued to greater depths here and this layer and hence more pressure from the remaining earth mass from above.
Answer:
When a wave is too steep to support itself, the wavefront collapses creating a <u> </u><u>break </u>that advances up the shoreline
Explanation:
When waves are tall, with a great slope that makes them unstable, they break. Braking waves might occur inshore or offshore.
- Offshore: Breaking waves in the deep sea occurs when the wind speed increases so fast that they exceed the speed of the waves. These last ones acquire additional energy from the winds increasing their slopes to the point of being so unstable that the water from the crest falls forward and breaks the wave. The most influencing factor in these breaking waves is the speed of the winds.
- Inshore: When waves are near the shore, the scarce water deepness increases the friction of the wave with the marine bottom, and consequently, the wave´s speed decreases progressively. The wave loses energy in the friction, the wave energy is concentrated in a lower length, and the wave grows in size. As it increases, it acquires a sharper slope. As deepness decreases, the wave base loses speed, but the crest does not. As the wave crest travels faster, the frontal face of the wave becomes concave. This change in shape continues until the wave can not support itself and it breaks. The break is not produced by the friction with the bottom, but by exceeding the slope limit values.
Answer: jaja lo siento y alguien puede venir a mi pregunta para ayudar a mi hermano ??? !!!!
Explanation:
