Answer:
The team did not adequately formalize the software's design
Explanation:
The most logical reason for this confusion is the fact that the team did not adequately formalize the the software design.
The design approach has to do with clearly defining the architectural modules of the application. The requirements in the software requirement specification document would serve as input for the next phase. The documents are prepared and they give a definition of the overall system architecture.
The team got confused because they did not go through this phase of the 10-phase SDLC model.
I think coders put in codes. Sry if that does not help.
Answer:
network 10.10.8.0 0.0.3.255 area 0
this will include all the interfaces on a device whose IP addresses only begin with a 10.10.8, 10.10.9, 10.10.10, or 10.10.11.
Explanation:
<em>show ip ospf interface
</em>
<em>show ip ospf interface brief</em>
these commands are used to display the interfaces that have been enabled into local ospf . it also shows explanation about them by brief command mentioned above.
<em />
I think its ' D ' ,You can use both A and B
