Select the examples that best demonstrate likely tasks for Revenue and Taxation workers. Check all that apply. Brenda works for
2 answers:
You might be interested in
Answer:
The time elapsed is 0.017224 s
Solution:
As per the question:
Analog signal to digital bit stream conversion by Host A =64 kbps
Byte packets obtained by Host A = 56 bytes
Rate of transmission = 2 Mbps
Propagation delay = 10 ms = 0.01 s
Now,
Considering the packets' first bit, as its transmission is only after the generation of all the bits in the packet.
Time taken to generate and convert all the bits into digital signal is given by;
t =
t = (Since, 1 byte = 8 bits)
t = 7 ms = 0.007 s
Time Required for transmission of the packet, t':
Now, the time elapse between the bit creation and its decoding is given by:
t + t' + propagation delay= 0.007 + + 0.01= 0.017224 s
Answer:
Following are the code to this question:
b= input()#defining b variable for input character value
h= input()#defining h variable for input character value
b_width=6#defining b_width variable that holds an integer value 6
r1 = ' ' * b_width+h#defining r1 variable that calculates hash lines
r2 = b*b_width+h*2#defining r3 variable that calculates 6 asterisk and 2 hash line
r3 = b*b_width+h*3#defining r3 variable that calculates 6 asterisk and 3 hash line
print(r1)#print r1 variable value
print(r2)#print r2 variable value
print(r3)#print r3 variable value
print(r2)#print r2 variable value
print(r1)#print r1 variable value
Output:
please find the attachment.
Explanation:
In the given python code, three variable "b,h, and b_width" is declared, in which "b_width" holds an integer variable "6" and variable "b and h" is used to an input character value. In the next line, "r1, r2, and r3" is declared, that holds arrowhead values which can be defined as follows:
- In the "r1" variable, it stores space with b_width variable and one h variable value.
- In the "r2" variable it stores b_width and 2*h variable value.
- In the "r3" variable it stores b_width and 3*h variable value.
At the last, it prints the "r1, r2, and r3" variable value and for arrowheads, it follows the above program code.
