Answer:
Section lines
Step-by-step explanation:
Sectioning is the process of cutting a surface by an imaginary plane, the view of the surface that is cut is shown in the section view.
Section lines are used to indicate where an imaginary cutting plane cuts a material. The imaginary cut is then represented using section lines which are usually thin, crosshatched.
Section lines shows the surface that have been cut by the cutting plane. There are different ways of sectioning such as full section, half section, off set section and so on
Answer:
The graphs are the same because both equations have the same slope, the y-intercept only changes the place of the line. The lines are different because one line is at a different location than the other because of the difference in y intercepts.
Step-by-step explanation:
Answer:
c. 6
Step-by-step explanation:
The degree of a vertex is the number of arc ends that intercept it. (The other end of the arc is irrelevant.)
Vertex A is connected to B (1), D (2), F (1), and itself (2). There are a total of 6 arc ends that meet vertex A. Its degree is 6.
