Answer:
Go on amazon and look for HDMI -> (VGA/DVI/HDMI) what ever you need adapters.
Answer:
Your question is lacking some information attached is the missing part and the solution
A) AB = AD = BD = 0, BC = LC
AC = 
B) AB = AD = BC = BD = 0
AC = 
Explanation:
A) Forces in all members due to the load L in position A
assuming that BD goes slack from an inspection of Joint B
AB = 0 and BC = LC from Joint D, AD = 0 and CD = 4L/3 C
B) steps to arrive to the answer is attached below
AB = AD = BC = BD = 0
AC = 
5000! Hope this helps! If you are confused feel free to ask again
The rovers were designed to trek up to 100 meters (about 110 yards or 328 feet) across the martian surface each martian day, though they have gone much farther. While a complete martian day (called a sol) is about 24 hours and 40 minutes long (or 24 hours 37.5 minutes if you prefer), the Sun can only provide enough power for driving during a four-hour window around high noon. That means the rovers have to be able to move quickly and effectively.
Moving safely from rock to rock or location to location is a major challenge because of the communication time delay between Earth and Mars, which is about 20 minutes on average. Unlike a remote controlled car, the drivers of rovers on Mars cannot instantly see what is happening to a rover at any given moment and they cannot send quick commands to prevent the rover from running into a rock or falling off of a cliff.
During surface operations on Mars, each rover receives a new set of instructions at the beginning of each sol. Sent from the scientists and engineers on Earth, the command sequence tells the rover what targets to go to and what science experiments to perform on Mars. The rover is expected to move over a given distance, precisely position itself with respect to a target, and deploy its instruments to take close-up pictures and analyze the minerals or elements of rocks and soil.
Answer:
Tech A is correct
Explanation:
Tech A is right as its V- angle is identified by splitting the No by 720 °. Of the piston at the edge of the piston.
Tech B is incorrect, as the V-Angle will be 720/10 = 72 for the V-10 motor, and he says 60 °.
