Answer:
CPU
I dont know a whole ton about computers. But I'm confident this is correct. Without the CPU the other options on this list wouldnt work so the CPU would be the "heart".
Answer: The best method to avoid getting spyware on a user machine is to download software only from trusted websites. And depending on the machine it might say that "This download you are about to install might have spyware or malware and it might infect your laptop" "Do you wish to continue?"
Answer:
The answer is "Option d"
Explanation:
Description to this query can be defined as follows:
- All of the three (User location, Location modifier, and viewport) are used to identify range demotions.
- The Viewport, the new user location in Houston, is a McDonald's address query, where the user looks for the exact location of McDonald's in the area of Austin.
- The location modifier and viewport are used to calculate the distance of the demotions Client position.
Answer:
Hi there, the only emails that go to the draft folder are the emails that you start to write and then you don't finish it so you can go back and finish writing it later.
Explanation:
<h2>Hope this helps!! Please consider marking brainliest! Have a good one!!</h2>
Answer:
The solution code is written in Python 3:
- def modifyList(listNumber):
- posCount = 0
- negCount = 0
-
- for x in listNumber:
- if x > 0:
- posCount += 1
- else:
- negCount += 1
-
- if(posCount == len(listNumber)):
- listNumber.append(max(listNumber))
-
- if(negCount == len(listNumber)):
- listNumber.append(min(listNumber))
-
- print(listNumber)
-
- modifyList([-1,-99,-81])
- modifyList([1,99,8])
- modifyList([-1,99,-81])
Explanation:
The key step to solve this problem is to define two variables, posCount and negCount, to track the number of positive value and negative value from the input list (Line 2 - 3).
To track the posCount and negCount, we can traverse through the for-loop and create if else statement to check if the current number x is bigger than 0 then increment posCount by 1 otherwise increment negCount (Line 5- 9).
If all number in the list are positive, the posCount should be equal to the length of the input list and the same rule is applied to negCount. If one of them happens, the listNumber will append either the maximum number (Line 11 -12) or append the minimum number (Line 14-15).
If both posCount and negCount are not equal to the list length, the block of code Line 11 -15 will be skipped.
At last we can print the listNumber (Line 17).
If we test our function using the three sets of input list, we shall get the following results:
[-1, -99, -81, -99]
[1, 99, 8, 99]
[-1, 99, -81]
