The syntax is truly dependent on the programming language, as different languages have different API's.
But, the most standard form of accessing an array length is via a method or property by dot notation.
For example -
for(int i = 0; i <= m_Array.Length; i++) {...}
This code is from C#, using the Length property.
Answer:
"Grid computing" is the correct answer for the above question.
Explanation:
- Grid computing is a process in which many computers are participating to solve a single problem. This type of process is distributed multiple computers to perform a different type of task.
- If there is large problem and if many computers solve that problem, then that problem is solved easily within a few minutes.
- This is because many computers are working for that problem.
- The above question asked about that process in which many computers are working to solve a single problem. This processor is known as "Grid Computing".
Recover as much of the R-502 from the recovery unit as possible, change filter, and evacuate. In addition, to alter the compressor on a system containing R-410A, the person must isolate the compressor then evacuate the isolated section of the system to atmospheric pressure and hold. If system pressure does not increase, then remove the compressor. The recovered refrigerant may encompass acids, moisture and oils and every air conditioning or refrigerating system should be secure by a pressure relief device.
Answer:
FULL neighbor state.
(FULL/DR or FULL/BDR)
Explanation:
The fact that the routers are neighbors is not enough to guarantee an exchange of link status updates; they must form adjacencies to exchange link status updates. Adjacency is the next step after the process of establishing neighbors. Adjacent routers are routers that go beyond a simple Greeting exchange and act in the database exchange process. To reduce the amount of information exchange in a given segment, OSPF selects a router as a designated router (DR) and a router as a designated backup router (BDR) in each multiple access segment. The BDR is chosen as the backup mechanism in case the DR fails. The idea behind this is that routers have a central point of contact for the exchange of information. In order to verify if two routers have established an adjacency, you can use the command: show ip ospf neighbor.
Here is an example:
R1#show ip ospf neighbor
Neighbor ID Pri State Dead Time Address Interface
203.250.12.1 1 2WAY/DROTHER 0:00:37 203.250.14.3 Ethernet0
203.250.15.1 1 FULL/DR 0:00:36 203.250.14.2 Ethernet0
203.250.13.41 1 FULL/BDR 0:00:34 203.250.14.1 Ethernet0
Answer:
See below:
Explanation:
AI is not embraced in every industry because of the type of industry and what it requires. In some situations, a human is needed since an AI cannot determine what to do and can sometimes even cause death.
AI isn't embraced everywhere because for some things we need a person, lets say for example, we need an AI to respond to 911 calls, that simply won't work due to the many situations and training the bot too will be a nightmare. For example, if a caller says a word that normal humans can understand, or a "code word" that every human knows but they haven't bothered to tell the bot, that will be the end of the line for them.
There are mutliple reasons to not use AI depending on the situation whether its life and death or just plain impractical.
