Answer:
Explanation:
Make sure resample is turned on
Turn on the chain link if you want the width and height to change together. If not, turn off the chain so that you can set your own width and height.
Choose your new size (you can choose to choose different measurement units by clicking on “inches”)
press ok
i hoped this helped!!!!!!!!
Answer:
Crosstalk, Jitter, Impulse noise.
Explanation:
Crosstalk is a network error that occurs when one pair of cable causes interference on another pair of cables thereby preventing efficient data transmission.
Jitter may also impair the accuracy of the data being transmitted across network because minute variations in amplitude, phase, and frequency always occur. The generation of a perfect carrier signal in an analog circuit is almost impossible. The signal may be affected by continuous and rapid network gains or phase changes.
Impulse noise (also referred to as spikes) is the primary source of errors in data communications. Impulse noise can be caused by positioning a communications cable near a source of intermittent but strong electromagnetic pulses, such as an elevator motor.
Counter measures
Shielding (protecting wires by covering them with an insulating coating) is one of the best ways to prevent impulse noise, cross-talk.
Amplifiers can be used to increase signal strength since the connection would run across 4 floors.
Answer:
//check which string is greater
if(strcmp(name1,name2)>0)
//assign name1 to first, if the
//name1 is greater than name2
first=name1;
else
//assign name2 to first, if the
//name2 is greater than name1
first=name2;
5)
//compare name1 and name2
if(strcmp(name1,name2)>0)
//compare name1 and name3
if(strcmp(name1,name3)>0)
//assign name1 to max, becuase
//name1 is greater than name2 and name3
max=name1;
Explanation: