Answer:
The typedef struct is as follows:
typedef struct jumper_t {
char name[16];
double tries[N_TRIES];
double best_jump;
double deviation;
} jumper_t;
The declaration of jlist is:
jumper_t jlist[10];
Explanation:
This defines the typedef structure
typedef struct jumper_t {
The following declares the variables as stated in the question
<em> char name[16];
</em>
<em> double tries[N_TRIES];
</em>
<em> double best_jump;
</em>
<em> double deviation;
</em>
}
This ends the typedef definition
jumper_t;
(b) The declaration of array jlist is:
jumper_t jlist[10];
Answer:
The answer is below
Explanation:
The amount of power dissipated by a processor is given by the formula:
P = fCV²
Where f = clock rate, C = capacitance and V = Voltage
For the old version of processor with a clock rate of f, capacitance C and voltage of V, the power dissipated is:
P(old) = fCV²
For the new version of processor with a clock rate of 20% increase = (100% + 20%)f = 1.2f, capacitance is the same = C and voltage of 20% increase = 1.2V, the power dissipated is:
P(new) = 1.2f × C × (1.2V)² = 1.2f × C × 1.44V² =1.728fCV² = 1.728 × Power dissipated by old processor
Hence, the new processor is 1.728 times (72.8% more) the power of the old processor
Answer:
From the two IP addresses, 192.168.2.1 can be listed as the default gateway in local network devices.
The reason is that we are allocated with the ranges that are reserved for the local networks by RFC 1918.
These ranges are given as follows:
10.0.0.0 - 10.255.255.255
172.16.0.0 - 172.31.255.255
192.168.0.0 - 192.168.255.255
Moreover the default gateway for a device can also be known by the commands ipconfig or ipconfig/all on the command prompt.
<h3>I hope it will help you!</h3>
