Answer:
Following are the function to the given question:
void same_quantity_inventory(inventory *arr, int size)//defining a method same_quantity_inventory that takes two parameters
{
inventory *p = arr;//defining a pointer variable that holds array value
while (p < arr + size)//defining while loop that checks pointer value less than arr and its size
{
if (p->endQty == p->beginQty)//use pointer to check array start and end value
printf("name: %s, start quantity: %d, end quantity: %d\n", p->name, p->beginQty, p->endQty);//print value
p++;//incrementing pointer value
}
}
Explanation:
In the given code a method "same_quantity_inventory" takes two parameters that are "arr and size". In the next step, a pointer variable "p" is declared that holds the "arr" value. It defines the while loop that checks pointer value less than arr and its size inside the loop and if block is declared that use pointer to check array start and end value, and prints its calculated value.
<span>The part of the computer that provides access to the internet is the "modem".
</span>
A modem refers to a hardware device that enables a PC to send and get information over a phone line or a link or satellite association. On account of transmission over a simple phone line, which was at one time the most prevalent approach to get to the internet, the modem changes over information amongst simple and computerized designs progressively for two-way network communication.
Answer: Performance testing
Explanation: Performance testing is the level of the software development life cycle which works for the evaluation of the system function and operations. The aim of the performance testing is to test the system under the extreme condition and find the critical problems related with it.
The performance of the throughput, functioning time, utilization of the central processing unit(CPU) etc are measured.This testing has the scale for measurement on the basis on scalability of the functions, speed of the system and the stability .
Answer:Full-interruption--A
Explanation: The Full-interruption is one of the major steps for a Disaster Recovery Plan, DRP which ensures businesses are not disrupted by saving valuable resources during a disaster like a data breach from fire or flood.
Although expensive and very risky especially in its simulation of a disruption, this thorough plan ensures that when a disaster occurs, the operations are shut down at the primary site and are transferred to the recovery site allowing Individuals follow every procedure, ranging from the interruption of service to the restoration of data from backups, also with the notification of appropriate individuals.