Given a table, with an input (x) and output (y) , you could actually use the slope formula to get the rate of change because slope is the same thing as rate of change. If you recall, the slope formula is (y2-y1)÷(x2-x1)
Just pick two points from the chart and plug them in and that is your rate of change
Answer:
No, the triangles are similar with a scale factor of ⅔
Step-by-step explanation:
Given that ∆TUV was transformed to ∆WXY, it means the original lengths of ∆TUV were multiplied by a scale factor that reduced the lengths of ∆TUV to get the lengths of ∆WXY.
AA scale factor of ³/2 will increase the lengths rather than reduce it.
Therefore, the scale factor that was used was ⅔.
Thus, ⅔ of UT will give you the size of XW. Check it out below:
UT = 12, therefore, ⅔*12 = 8.
Answer:
-4
Step-by-step explanation:
22x-5x=17
-17+-4=-21
Answer:
B, C, D
Step-by-step explanation:
9x4=36 Yes
12x3=36 Yes
6x6=36 Yes
9x9=81 No
8x4=32 No
