All categories

1 year ago

Why is preshaping or pre machining of parts generally desirable in the non-traditional machining processes?

Social Studies

1 answer:

harkovskaia [24]1 year ago

4 0

Final answer :

Pre Machining involves removing some extended micro rough areas from the workpiece that are undesirable for advanced manufacturing processes.

<h3>What is pre-machining? What three different machining processes are there?</h3>

Roughing operations are used to quickly remove huge amounts of material and create parts with geometry that closely resembles the desired shape. Following roughing, a finishing procedure is utilised to get the desired final geometry and surface finish.

Turning, drilling, and milling are the three main machining operations. Shape-changing, planing, drilling, broaching, and sawing are additional processes that fall under the umbrella term "other operations."

Explanation :

Because of its superior surface smoothness and low dimensional inaccuracy, pre-machining is essentially beneficial and desirable for any advanced manufacturing processes.

For instance:

If pre-shaping is not done in EDM (Electric discharge machining), there may be chances of arcing in the material removal zone. Hence that results in inaccurately measured dimensions.

To learn more about Machines visit:

brainly.com/question/21306589

#SPJ4

You might be interested in

When this theatrical design style is used, the audience sees the story through the mind of one character. Settings may be distor

uranmaximum [27]

Answer:

scrim, I think

Explanation:

sorry if its not right but im prettry sure it is

5 0

2 years ago

Review the map that shows earthquake zones as yellow lines and active volcanoes as red dots. What pattern can you determine abou

Reptile [31]

The pattern shown is that the location of active volcanoes are usually found in the earthquake zones around the world.

The reason why the earthquake zones are long lines is because they are along tectonic plate boundaries which are found across the globe.

<h3>How are active volcanoes and earthquake zones related?</h3>

Active volcanoes will usually be found in earthquake zones because earthquake zones are located along the boundaries of tectonic plates.

When these plates collide with each other, earthquakes happen which is why these are earthquake zones.

These collisions also provide access to the surface for the lava in the mantle and so volcanic eruptions take place as well.

Find out more on tectonic plates at brainly.com/question/838446.

3 0

3 years ago

Select two men who broke the catholic church

QveST [7]

John and Martin Luther

4 0

3 years ago

Which landform region is being described? A low, bowl-shaped land with higher ground all around it. A. piedmont B. volcano C. ba

Sindrei [870]

That's going to have to be d

3 0

3 years ago

Tax cuts are a contentious political issue. Some politicians argue that tax cuts tend to benefit people with higher incomes more

kramer

Answer:

Equity(fair).

Explanation:

Tax cut in usual term is demonstrated as the rebate or reduction in the tax rate paid by the citizens to the government. Tax cuts are often considered as controversial political issue as some of the politicians assert that these cuts tend to serve more as a gain for the higher-income as compared to the lower-income groups which economists would categorize as a step taken in regard to establish the 'equity' among the tax rates. Because it becomes quite impartial or unfair to charge a higher tax rate from the higher-income groups and lesser from the lower-income groups. Therefore, the step is in regard to 'equity'.

8 0

3 years ago