Answer:
Consider the following code.
Explanation:
save the following code in read_and_interp.m
function X = read_and_interp(s)
[m, n] = size(s);
X = zeros(m, 1);
for i = 1:m
if(str2num(s(i, 2:5)) == 9999)
% compute value based on previous and next entries in s array
% s(i, 2:5) retrieves columns 2-5 in ith row
X(i,1) = (str2num(s(i-1 ,2:5)) + str2num(s(i+1,2:5)))/2;
else
X(i,1) = str2num(s(i,2:5));
end
end
end
======================
Now you can use teh function as shown below
s = [ 'A' '0096' ; 'B' '0114' ; 'C' '9999' ; 'D' '0105' ; 'E' '0112' ];
read_and_interp(s)
output
ans =
96.000
114.000
109.500
105.000
112.000
Answer:
it would be nice if you gave some form of info here
Explanation:
in other words without information no help aka I'm slow and just need points
The simplest ways are being used to help eliminate the previously stored data, by deleting hard disc storage facilities with the same data wherever that used a sequence of all zeros.
<h3>What is a hard disc?</h3>
The "DoD Standard" is a term used during the data sanitizing industry and refers to DoD 5220.22-M, and the further discussion can be defined as follows:
The simplest ways are being used to help eliminate the previously stored data, by deleting hard disc storage facilities with the same data wherever that used a sequence of all zeros.
The sparging eliminates statistics to entirely delete the gravitational flux from electronic media.
Hard drives as well as other data storage devices, for example, computer tapes, retain magnetic data.
It could no longer be seen as storage after a disk is degaussed.
Therefore, the final answer is "Using the DoD 5220.22-M method and Degauss media with a magnet".
Learn more about hard disc at:
brainly.com/question/13329582
#SPJ1
The dual-layer-IP allows ipv4 and ipv6 at the network layer to access a single tcp/udp stack.
<h3>What is the dual IP layer?</h3>
The word dual-stack is a word that connote a full or total duplication of all stages in the protocol stack ranging from its applications to the network layer.
Note that the dual-layer-IP method often gives room for a computer to run IPv4 and IPv6 simultaneously at the network layer, and all of the IP stack can access a different TCP/UDP stack.
Learn more about architecture from
brainly.com/question/9760486
