Answer:
Written in Python
name = input("Name: ")
wageHours = int(input("Hours: "))
regPay = float(input("Wages: "))
if wageHours >= 60:
->total = (wageHours - 60) * 2 * regPay + 20 * 1.5 * regPay + regPay * 40
else:
->total = wageHours * regPay
print(name)
print(wageHours)
print(regPay)
print(total)
Explanation:
The program is self-explanatory.
However,
On line 4, the program checks if wageHours is greater than 60.
If yes, the corresponding wage is calculated.
On line 6, if workHours is not up to 60, the total wages is calculated by multiplying workHours by regPay, since there's no provision for how to calculate total wages for hours less than 60
The required details is printed afterwards
Note that -> represents indentation
Answer:
"a callout is a type of text box that also includes a line for pointing to any location on the document. A callout appears under the SHAPES menu of the word processing program. The answer that completes this statement is the word "shapes". Hope this answers your question."
Explanation:
Answer:
Check the explanation
Explanation:
CPI means Clock cycle per Instruction
given Clock rate 600 MHz then clock time is Cー 1.67nSec clockrate 600M
Execution time is given by following Formula.
Execution Time(CPU time) = CPI*Instruction Count * clock time = 
a)
for system A CPU time is 1.3 * 100, 000 600 106
= 216.67 micro sec.
b)
for system B CPU time is 
= 333.33 micro sec
c) Since the system B is slower than system A, So the system A executes the given program in less time
Hence take CPU execution time of system B as CPU time of System A.
therefore
216.67 micro = =
Instructions = 216.67*750/2.5
= 65001
hence 65001 instruction are needed for executing program By system B. to complete the program as fast as system A
Answer:
The answer is "None of these".
Explanation:
In the given question an array "sales[]" is declared, which contains 50 double type elements, and in the next line, an integer variable j is defined, which uses a for loop. In this question two options is given, in which both are not correct, that can be described as follows:
- In option (i), A loop is defined that, uses variable j which starts with 0 and ends with 48, So total elements are 48 that's why it is not correct.
- In option (ii), A loop will use variable j that, starts with 1 and ends with 49, That's why it is not correct.
Answer:
From the two IP addresses, 192.168.2.1 can be listed as the default gateway in local network devices.
The reason is that we are allocated with the ranges that are reserved for the local networks by RFC 1918.
These ranges are given as follows:
10.0.0.0 - 10.255.255.255
172.16.0.0 - 172.31.255.255
192.168.0.0 - 192.168.255.255
Moreover the default gateway for a device can also be known by the commands ipconfig or ipconfig/all on the command prompt.
<h3>I hope it will help you!</h3>