Answer:
Option(A) is the correct answer to the given question .
Explanation:
Following the steps for adding the data series into the Chart Tools is given below
Step 1: Choose the data from the spreadsheet
Step 2: Choose the data button or data group.
Step 3: After that press on the add button.
Step 4:: Finally choose the range of the data from the excel sheet .
- Option(A) follows the correct syntax to adding the data series into the chart Chart tools that's why it is correct option .
<span>Current Procedural Terminology
is used for general check up
</span>
This question is incomplete. The complete question is given below:
Your company has just brought a new 22-core processor, and you have been tasked with optimizing your software for this processor. You will run four applications on this system, but the resource requirements are not equal. Assume the system and application characteristics listed in table 1.1
Table 1.1 Four Applications
Application
A
B
C
D
% resources needed
41
27
18
14
% parallelizable
50
80
60
90
The percentage of resources of assuming they are all run in serial. Assume that when you parallelize a portion of the program by X, the speedup for that portion is X.
a. How much speedup would result from running application A on the entire 22-core processor, as compared to running it serially?
Answer:
Speedup = 50
Explanation:
- The speedup for that portion is x if we parallelize a portion of that program by X.
- If the whole program has no parallelize portion or in other words the whole program is running serially then the speedup will be zero.
- So in this scenario if parallelizable portion of A is 50% so according to above description the speedup is 50.
When you were to choose the setting when exiting, the next step that would appear to happen would be the fact that the drive or the chip it's self would just stop. It would continue to work,but the main focus would be that it would not be functional.
