The most likely problem which led to the lack of sound after the installation of the new sound card is that the '<em>sound card is not recognized or incompatible</em> '
- The sound card is an hardware which is installed into a computer in other to allow the the system produce audio signal.
- Without a sound card installed into a computer, then such computer would not be able to perform <em>audio</em> <em>input or produce audio signals</em>.
However, when a sound card is present and, the computer fails to produce audio signal, then the most likely problem is that, the <em>sound card installed isn't recognized</em>.
Learn more :brainly.com/question/25055825
Answer:
The "service password-encryption" global configuration command encrypts passwords configured before and after the command is issued.
Explanation:
A switch is an intermediate network device that is used to transfer frames to nodes on its collision domain. It operates in the Data-link layer of the OSI model.
Switches uses media address control (MAC) table, containing the MAC addresses of the nodes in the network, to determine the destination of nodes.
In the global configuration mode in a switch, the password and other protocols are configured. The service password-encryption command in the global execution mode encrypts passwords configured before and after the command.
A volcano because its always erupting
Answer:
The answer is "Option d".
Explanation:
In networking, NAT refers to the Network Address Translation. This process is used to translate computer IP addresses into a single IP address in your local network. It allows private IP networks to connect to the Internet using unregistered IP addresses. and other options are incorrect that can be described as follows:
- In option a, SSL stands for Secure Sockets Layer. It is used in transmission of documents or data over a network that's why it is not correct.
- In option b, RADIUS stands for Remote Authentication Dial-In User Service. It is used to manage the data on a network.
- In option c, PPTP stands for Point-to-Point Tunneling Protocol. It is used to provide a set of rules for communicating through a network that's why it is not correct.
A virus, malware, unplugged, used too much storage, etc.