Answer:
you have to let the 3D printer cool off for 15 minutes before turning it back on. once you turned it back on and then you can test the filament and after that it should start working.
Explanation:
so don't touch it for 15 minutes and just leave it alone . if it doesn't work in 15 minutes and leave it for 24 hours completely off and no one touches it.
Answer:
dual-core (two), quad-core (four) and octa-core (eight)
Explanation:
These are the most common according to my research.
If I helped you, can I please have brainliest?
Have a great day/night!
Answer:
SONET was the only one on the list created near the 1980s (1985)
Good luck!
<em>~Awwsome</em>
Answer:
A. Rogue access point
Explanation:
A rogue access point is defined as a wireless access point installed on a secure network infrastructure without consent of the owner of the network or without due authorization. While this can sometimes be added by a malicious attacker, it is most commonly set up by employees with the desire to have wireless access even when there is any available.
In the question, there are three wireless networks, but on scanning, five wireless networks were found, hence they are rogue access point.
For MS Word 2010 and higher
Go to "View" and find checkbox "Ruler"
