4 Types Of Dimmers :
1. Incandescent/Halogen
2. Magnetic Low Voltage (MLV)
3. Fluorescent
4. Light Emitting Diode (LED)
These are the different types of switches :
1. A single-pole switch controls lights from a single location. ...
2. A 3-way switch provides two separate control locations and is best used with recessed lights. ...
3. A 4-way switch provides for three or more dimming locations.
4. Switches are wired to the "hot" conductor in a wall box.
<em>I hope that my answer helps!</em>
A 50-year-old African American man
Answer:
Check the explanation
Explanation:
A packet filter firewall is used as a check point between internal corporate network to the outside internet. It blocks all the inbound traffic from the outside hosts trying to initiate a direct TCP connection to the internal corporate webserver. The network design with firewall is shown in the attached image below:
The figures in the attached image below shows an internal corporate network is protected with a packet filter firewall to minimize the inbound traffic from the external network or an internet. Therefore, the packet filter is used as a check point between the network.
The packet filter blocks all attempts by the outside hosts in order to initiate a direct TCP connection to the internal webserver of the internal corporate network.
Going by the second part of the attached image below can can therefore conclude that:
• Rule 1 specifies that, deny any packet with the destination address 5.6.7.8 if the STN flag of TCP header is set.
• Rule 2 specifies that, allow the inbound email traffic from the external source.
• Rule 3 specifies, allows the Outbound TCP traffic from the internal corporate network.
• Rule 4 specifies, allows outbound Email traffic from the internal corporate network to the external network.
• Rule 5 specifies, block any traffic from any source to the any destination.
Answer:
Quite simply, when you double your ISO speed, you are doubling the brightness of the photo. So, a photo at ISO 400 will be twice brighter than ISO 200, which will be twice brighter than ISO 100.
Explanation:
ISO most often starts at the value of ISO 100. This is the lowest, darkest setting, also called the base ISO. The next full stop, ISO 200, is twice as bright, and ISO 400 is twice as bright than that. Thus, there are two stops between ISO 100 and 400, four stops between 100 and 1600, and so on.
Commenting. When someone comments of a blog the blog's writer can comment back, to answer questions, etc.