Answer:
The complete sentences are:
<em>The VLOOKUP function structure begins with =VLOOKUP(value, table, col_index, [range_lookup])</em>
<em>To use the VLOOKUP function, the lookup value should be in the first column of the table.</em>
<em></em>
Explanation:
Required
Complete the given sentence with the right values
In Excel, the syntax of the VLOOK function is:
<em>=VLOOKUP (value, table, col_index, [range_lookup])</em>
value -> The value to look up to and it should be located in the first column of the table
table -> The table name
col_index -> The column number to check
[range_lookup] -> This is optional and it returns either true of false depending on the result of the query,
Answer:Disk
Explanation:Disk is the storage device in which data can be rewritten and stored.They work in the computer system internally as well as externally as per the requirement
To evaluate the monitor disk performance and disk subsystem performance, it is checked whether the particular part of the computer system is working along with rest of the parts . If the working of the part is not along with other components then there will be a reduction in the performance of the system , as to keep that part on the track.
Disk is responsible for this tracking and pacing system.
Hi mate, not an expert on this but you would need a standard hdmi cable 4k 120hz as then the right power supply would be going through because as i’m sure you know pcs and tvs work differently. sorry if that doesn’t make sense but i hope it does :)
Answer:To create your own electromagnet, you will need the following materials:
Large iron nail (approximately 3 inches in length)
Thin coated copper wire
Dry cell batteries
Electric tape
Iron fillings, paper clips and other magnetic items
Procedure
Take the 3-inch nail and the thin covered copper wire, and wrap the copper wire around the nail, leaving at least 10 inches of it at the end. Make sure you don’t overlap the wires when you wrap it around the nail. Take your scissors or cutter, and cut the wire allotting about 8 to 10 inches on the other end too.
The next step is to attach the wires to the terminals of the battery. Do this by first peeling the plastic covering off the copper wire, and attach one end to the positive terminal of the dry cell battery, and the other end to the negative terminal of the battery. Get your electric tape and tape both ends of the wire to the battery terminals to keep them in place.
Get your iron fillings, paper clips and other magnetic items available at your place then test your electromagnet.
