Answer: scale (chemistry), the range of mass or volume of a chemical reaction or process.
Explanation:
:D h
The BIOS feature that enables a hard drive to read or write several sectors at a time is called IDE block mode
Explanation:
IDE block mode setting speeds up IDE drivers when enabled by allowing multiple sectors to read or write operations. This BIOS feature rushes up hard disk drive passage by transferring many divisions of data per interrupt rather than using the normal single-sector transfer mode.
This mode of transfer is known as block transfers. When block transfers are enabled, depends on the IDE controller, nearly 64 KB of data can be transferred per interrupt.
An alternative to hexadecimal notation for representing bit patterns is dotted decimal notation in which each byte in the pattern is represented by its base ten equivalent. In turn, these byte representations are separated by periods. For example, 12.5 represents the pattern 0000110000000101 (the byte00001100 is represented by 12, and 00000101 is represented by 5), and the pattern 100010000001000000000111 is represented by 136.16.7. Represent each of the following bit patterns in dotted decimal notation,
a. 0000111100001111 b. 001100110000000010000000c. 0000101010100000
<u><em>Differences between barcode reader and character recognition devices:</em></u>
Barcode Reader or Barcode Scanner:
- Barcode Scanner scans the data by brightening the barcodes usingSensor
- The analog signal is then converted into digital signal by Converter.
- The Decoder calculates the converted data and sends valid data to the computer.
Character Recognition Devices (OCR):
- OCR scans the physical document and converts them into two-coloured format.
- The darker and lighter area are identified as characters and blanks respectively.
- The common methods used are: Pattern Recognition and Feature Detection.
Answer:
The answer is "Pass the cable into the ceiling instead of over the floor".
Explanation:
Network access explains the complex process of link different parts of the network with each other, e.g. while using switches, routers, and access points, and whether, that system works.
- To replace the cable with a pair cable graded in plenum, covered, twisted.
- We use the cable to pass through the ceiling rather than through the concrete, eliminating the issue and stopping it from occurring again.
