The program does not consists of any syntax error but the module contains error in logic especially while placing the condition inside if statement.
Here we are actually planning to check whether the number passed in the “value” variable is within the given lower and upper range which is passed in second and third parameter.
Solution 1:
if value<=lower AND value>=upper Then
Display “The given number is outside the specified range.”
else
Display “The given number is within the specified range.”
End if
Alternate solution:
So for that the condition needs to be value>=lower and value <=lower. so
if value > lower AND value <upper Then
Display “The given number is within the specified range.”
else
Display “The given number is within the specified range.”
Answer:
Intrusion Prevention System (IPS)
Explanation:
Firewall can be defined as a network security device that monitors incoming and outgoing network traffic and decides whether to allow or block specific traffic based on a defined set of security rules.
Simply stated, a firewall is a network security protocol that monitors and controls inbound and outbound traffic based on set aside security rules.
A firewall is used to control access to a computer or network, as it creates a barrier between a computer or a network and the internet in order to protect against unauthorized access.
Basically, it is a network security device or security system pre-installed on most computers to essentially inspect data being transmitted to or from a computer
Thus, the tool you should use is an intrusion prevention system (IPS).
Answer:
monitor fileSharer
{
enum {THINKING, WAITING, READING} state[N];
condition self[N];
int total;
void open(int i) {
state[i] = WAITING;
if (i + total >= N)
{ self[i].wait(); } // Leaves monitor
state[i] = READING;
total += i;
}
void close(int i) {
state[i] = THINKING;
total -= i;
// Can signal one waiting proc whose ID won't break bank.
for (int x = N - total - 1; x >= 0; x--) {
if (state[x] == WAITING) {
self[x].signal(); break;
}
}
}
initialization.code() {
for (int i = 0; i < N; i++) {
state[i] = THINKING;
}
total = 0;
}
}
A learning management system (LMS) is a software application for the administration, documentation, tracking, reporting and delivery of educational courses or training programs.
