Answer:
One sheave means that you are using a single drum winder. They are the worst! Double drum winders control easier, brake better and are much more efficient. They save time ( two skips or cages) and can be clutched to perform faster shift transport. A single drum is slow, unbalanced and can be a nightmare if it trips out during hoisting. If the brake system is not perfect it can be a real hairy experience. For a runaway single drum, there is no counterbalance effect. It always runs to destruction. With a double drum, the driver still has a chance to control the winder to a certain extent and he has two sets of brakes to rely on. A single sheave could also mean a shaft with a single compartment. No second means of escape unless there are ladders or stairways. Not a very healthy situation.
Those are just a few points. I am sure much more can be said in favor of a double drum winder and two or more sheaves in the headgear. Most of the shafts I have worked at have multiple winders and up to ten compartments. They all have a small single drum service winder for emergencies and moves of personnel during shift times. They are referred to as the Mary - Annes. Apparently, the name originated in the U.K. where an aristocratic mine owner named the first such winder after his mistress.
Explanation:
<em>Hope you got it </em>
<em>If you have any question just ask me</em>
<em>If you think this is the best answer please mark me as BRAINLIEST</em>
Alt and tab to switch to open applications
Type "ifconfig" at the terminal prompt, then press the "Enter" key. The IP address is labeled as "inet addr." The subnet is labeled as "Mask."
step 2
Type "netstat -r" at the command prompt, then press the "Enter" key to view the gateway address.
Answer:
divide it into smaller pieces
Explanation:
Usually, the main reason a programmer does not understand a problem fully is that there is too much information. The best way to try and fully understand a problem is to divide it into smaller pieces. Start off by answering the question what is the expected output for an input. Then divide each individual issue within the problem. This will allow you as a programmer/developer to create an individual solution for each individual issue within the problem and then test to make sure that the input gives the correct output.
