Answer:
(3) y=(x+3)
Step-by-step explanation:
I'm not sure what is the parent function, but in most graphs if you will shift it to the left or right (negative sign or positive sign, respectively), it will be inside a parenthesis and the opposite sign is the real movement.
For a cubic function these will be the movements:
f(x)=(x+/-h)^3+/-k
Only the opposite sign of h will be the real movement, while k's sign will automatically indicate the correct movement.
h= x-axis movement (horizontal, inside of the parenthesis in the equation)
k= y-axis movement (vertical, outside of the parenthesis in the equation)
Hope it helps
Answer:
23 sin 55°
x = ------------------ (matches first answer choice)
sin 85°
Step-by-step explanation:
Note that 2 angles and 1 side length are given. This is a typical application of the Law of Sines. The formula for finding the length of side x is:
23 sin 55°
x = ------------------ (matches first answer choice)
sin 85°
Answer:
-10
Step-by-step explanation:
Assuming that x-2=-5, we can subtitute it into the equation as follows:
(-5)^2 + 5(-5) - 10, we start off with the exponent according to the order of operations resulting in:
25 + 5(-5) -15, then we do the multiplication next:
25 + (5 * -5 = -25) so:
25 + -25 - 10, the 25s cancel each other out and your left with:
0 - 10 which equals -10
Answer:
Diameter of circle while measuring vertically=3.5 cm
Diameter of circle while measuring Horizontally=3.6 cm
As you have not written by which instrument from geometry box you have measured the length of diameter.
1. By Scale i.e ruler 2. By Divider Or 3. By mere Observation i.e by comparing length
1.If you have done measurement by simply observation there are maximum possibility of having error.
2. Then if you have measured these lengths by scale or ruler there is very less chances of getting error in measurement of length because sometimes divison in scale varies i.e if a point lies between 4.5 to 4.6 we can't say exactly whether it is 4.5 or 4.6.
3. So it is better to compare line segments by Divider.There is no chances of getting error.
Most probably you have measured Diameter by ruler, Due to that you have faced the problem.
