A Deceleration device.
A rope, wire rope, or strap with connectors at each end for connecting the 5 point body harness to a lifeline, or anchorage.
Look under OSHA Flashcards on Quizlet and..
OSHA: Fall Protection in Construction, Subpart M and just past that area in the document.
This is from that document on page 13 and 14:
Fall Restraint Systems: While fall restraint systems are not
mentioned in Subpart M, OSHA
recognizes a fall restraint system as
a means of prevention. The system,
if properly used, tethers a worker
in a manner that will not allow a
fall of any distance. This system is
comprised of a body belt or body
harness, an anchorage, connectors,
and other necessary equipment.
Other components typically include
Photo: Skip Pennington
OCCUPATIONAL SAFETY AND HEALTH ADMINISTRATION
1 4
a lanyard, a lifeline, and other devices. For a restraint system
to work, the anchorage must be strong enough to prevent the
worker from moving past the point where the system is fully
extended, including an appropriate safety factor.
*In a November 2, 1995 interpretation letter to Mr. Dennis
Gilmore, OSHA suggested that, at a minimum, a fall restraint
system must have the capacity to withstand at least 3,000
pounds or twice the maximum expected force that is needed
to restrain the person from exposure to the fall hazard. In
determining this force, consideration should be given to
site-specific factors such as the force generated by a person
(including his/her tools, equipment, and materials) walking,
slipping, tripping, leaning, or sliding along the work surface.
Answer:
They assist the hero in difficult situations
Explanation:
because its right
Boolean operators are like AND,or,not,and not .
they are <span>used as conjunctions to combine or exclude keywords in a search, resulting in more focused and productive results.</span>
Answer:
The rules which could trigger at any period in time are referred to as the conflict set. A programming bug/conflict can occur when two programs compete for the same resource such as memory or register etc.
A Conflict Resolution Strategy is is a protocol which highlights which decision will be triggered first.
The best way to resolve conflict is to first determine the kind of conflict it is. Hardware conflicts can be resolved by first troubleshooting the hardware and in some instances unplugging the hardware causing the conflict.
When hardware creates conflicts it may be due to a driver issue. reverting to an old driver or updating the existing one may solve the problem.
Software conflicts can be resolved by installing updates or complete uninstallation.
Cheers!
