Answer:
2535
Step-by-step explanation:
Answer:
8. The coordinates (0,0) represent the fact that when 0 minutes has passed, the horses have gone 0 miles because they hadn't started yet.
9. From the graph, it looks like horse A takes 4 minutes and horse B takes 2.5 minutes (aka 2 minutes and 30 seconds) to travel 1 mile.
10. For A: y = (1/4)x
For B: y = (2/5)x
11. For A: 3 miles
For B: (24/5) miles, or 4 and (4/5) miles.
12. Can't see the entire problem sorry.
Step-by-step explanation:
9. You find this by going to y=1 and look towards the right till you find the point the line intersects with y=1. Then find the x value by finding the corresponding number on the x axis.
10. A linear function will look something like this: y = mx+b, where y is the y value, x is the x value, m is the slope, and b is the y-intercept. Since both lines start from 0, you don't have to write the y-intercept since there's no point in writing +0. To find slope, you find delta y over delta x. Basically just find the difference of two y values and the difference of two x values from the same coordinate in the same order. I know that sounds really confusing but your teacher will probably teach this later on.
11. x represents the time, so just substitute x as 12 in the equation.
Answer: Fatigue level
Step-by-step explanation: Dependent variable refers to the measured or observed variable in an experimental study. The dependent variable is the variable observed or studied in other to make assessment of effects which occurs by varying the independent variable. In the study described above, the self reported fatigue level is measured or recorded while subjecting the participant to varying conditions of noise; white noise and normal noise level, which are the independent variables. The dependent variable, fatigue level is the variable being measured in the experiment by subjecting the participants to the two different traet ment conditions which are the independent variables.
I started at (-2, 0) but you can start at any point on the graph that goes through the corner of the square (if that makes sense) like a point on the graph. From one point to the next, you go down one and one to the right, therefore the slope is a -1
Answer:
1.
- Heat capacity is defined as the total amount of heat required to increase the temperature of a substance in 1°C.
- Specific heat is defined as the total amount of heat required to increase the temperature of a substance in 1°C per unit mass. Hence this property depends of the mass of the substance.
- Latent heat is the amount of energy absorbed or released by a substance in a phase change (physical change) without a change in temperature.
2.
- Degrees of freedom is the number of parameters that define the configuration of a system. For example, in a system with we want to know about the dynamic in the three dimension x,y,z and also about the rotation around a fixed axe we have four degrees of freedom.
- Equipartition theorem relates the temperature of a system with the average energy of the system (this average is taken for those degrees of freedom that appears quadratically).
I hope this is useful for you
regards
