Answer:
Runtime error probably. The program won't make it past the while loop in the code.
Answer:
FF-FF-FF-FF-FF-FF and 255.255.255.255
Explanation:
FF-FF-FF-FF-FF-FF can be defined as the layer 2 address broadcast which is often used on ethernet frames as well as help to broadcast all equipment due to the fact broadcast is made possible through Ethernet networks in which the Frames are addressed to reach every computer system on a given LAN segment as far as they are addressed to MAC address FF:FF:FF:FF:FF:FF.
255.255. 255.255 can be seen as the layer 3 address which help to address the exact same hosts because it enables the broadcast address of the zero network which is the local network due to the fact that the IP broadcasts are often used by BOOTP and DHCP clients to find and send requests to their respective servers in which a message sent to a broadcast address may be received by all network-attached hosts.
Therefore the Layer 2 and Layer 3 destination addresses which the message contain are FF-FF-FF-FF-FF-FF and 255.255.255.255
Answer:
Answer is A: place absorbent chemical packets in the camera cover
Explanation:
Keith is required to carry adequate gear while going for a shoot. And in this case, he should carry anything that will protect his camera from the ocean and rainwater. By anything, I mean anything that Keith will use to stay dry. Using an air conditioner would be the worst idea. An air conditioner might blow the air towards your camera. Placing the camera in its case will ensure that it is dry and Keith will keep on shooting. Placing absorbent chemical packets in the camera cover will ensure that any water droplets that might fall on the cover of the camera will be absorbed. The point here is to keep dry.
