Answer:
see below
Step-by-step explanation:
A protractor is usually a transparent measuring device laid intended to be laid over an angle to be measured. The centerpoint of the protractor's scale is made to coincide with the angle's vertex, and the baseline of the protractor is aligned with one of the angle's rays. The appropriate scale is used to read the angle where the other ray crosses the scale. You usually have to visually determine if the angle is acute or obtuse, so you can choose the correct scale to read.
__
If you're drawing an angle, first draw one ray and locate the vertex on it. Then do the steps above as you would for measurement. Make a mark on your paper corresponding to the desired angle measure, and connect the vertex to that mark to create the other ray of the angle.
__
If you're working with a printed protractor, you may need to do your work on a piece of translucent paper or transparency material, so you can see the protractor scale through the page you're drawing on.
_____
<em>Comment on a printed protractor</em>
A protractor will only give accurate measurements if its geometry is perfect. Some printers will scale a figure differently in horizontal and vertical directions, so will make the protractor scale be elliptical instead of circular. That will give wrong readings.
The difference between the two polynomials is 11x²3y³ - 4xy².
<h3>What is the Difference between the Polynomials?</h3>
The difference between two polynomials is the result you get by subtracting one from the other.
Thus:
= (4x²2y³ + 2xy² – 2y) – (–7x²y³ + 6xy² – 2y)
= 4x²2y³ + 2xy² – 2y + 7x²y³ - 6xy² + 2y
= 11x²3y³ - 4xy²
Learn more about polynomials on:
brainly.com/question/2833285
#SPJ1
Answer:
umm... i belive yes.
Step-by-step explanation:
this is beacuse..
800 opposite wold be -800 right
and then the opposite of -800 wold be 800
so 800 is equal to 800 cus ya
so yes i belve that this is true.
Answer:
17
Step-by-step explanation:
for number 10 the answer is 24 - 7 = 17
Answer:
B
Step-by-step explanation:
its hard to explain, but just trust me bro. lol.