Kids in Cars is a Missouri-based, nationwide, non-profit
organization devoted to averting injuries and deaths that happen due to
children being left unattended in or nearby motor vehicles. Kids in Cars has boarded
on a task to follow preemptive legislation in all 50 states to make guarantee
that no child is ever, not even for a minute, left unaccompanied in or nearby a
motor vehicle
Increasing the concentration of carbon dioxide increases the rate of photosynthesis, as there is a greater supply of it that can be used. Of course, you can only add so much carbon dioxide before the plant can’t perform photosynthesis at an any faster rate. Increased carbon dioxide concentration will increase the rate of photosynthesis until it is no longer the limiting factor in the reaction.
Answer:
The correct answer is option C.
Explanation:
The slugs prefer pink flowers over the white ones. Thus, if the slugs are withdrawn from the population, the pink flowers are no more consumed and their number enhances. In a similar manner, the bees like to pollinate more pink flowers in comparison to the white ones.
Thus, again, the pink flowers are getting pollinated in huge concentrations. Thus, the fruits and seeds are set and they produce another generation of pink flowers. Ultimately, there would be more pink flowers in the region in comparison to the white ones as the slugs that used to consume them, are also withdrawn.
Earlier, both the numbers of pink and white flowers would remain steady as even though only some of the bees were pollinating white flowers, they were not getting consumed by the slugs. This had maintained a balance between the number of pink and white flowers. Thus, the number of pink flowers would increase with time if the slugs are removed.
Answer:
In the absence of decomposers, soil, air, and water would not be replenished, and all the nutrients present would soon get exhausted. Hence, the cyclic process of life and death would be disrupted and life would come to an end.
The answer is yes. Resistance measurement is used when you switch your multimeter into resistance mode and it is also measured in ohms. It is important to place at the right polarity of the multimeter in order to get the right measurement of your electronic device.
