1answer.
Ask question
Login Signup
Ask question
All categories
  • English
  • Mathematics
  • Social Studies
  • Business
  • History
  • Health
  • Geography
  • Biology
  • Physics
  • Chemistry
  • Computers and Technology
  • Arts
  • World Languages
  • Spanish
  • French
  • German
  • Advanced Placement (AP)
  • SAT
  • Medicine
  • Law
  • Engineering
Anni [7]
3 years ago
10

Technician A says that a lead acid battery uses straight Hydrochloric acid for electrolyte. Technician B says that a lead acid b

attery uses straight sulfuric acid for electrolyte.
Computers and Technology
2 answers:
konstantin123 [22]3 years ago
7 0

Technician B is correct

It is safe to say that Lead acid uses sulfuric acid. When fully charged, the electrolyte consist of 40% concentrated sulfuric acid and the remainder consist of mostly water. However, as it discharges, both the positive and the negative plates turn into lead sulfate with the electrolyte loosing much of its dissolved sulfuric acid and water.

Tema [17]3 years ago
4 0

Technician A is correct because i tried Technician B and it was wrong so its Technician A

You might be interested in
What is meant by concentration of a solution​
Bad White [126]

Answer:

The concentration of a solution means the amount of solute present in a given or specific amount of solution. (presented in percentage)

For example, the Normal Saline solution normally used for different scientific experiment or so. The saline water has 0.9% of salt (sodium chloride). This is the concentration of solution of salt.

5 0
3 years ago
Read 2 more answers
) Consider a router that interconnects four subnets: Subnet 1, Subnet 2, Subnet 3 and Subnet 4. Suppose all of the interfaces in
erik [133]

Answer:

Check the explanation

Explanation:

223.1.17/24 indicates that out of 32-bits of IP address 24 bits have been assigned as subnet part and 8 bits for host id.

The binary representation of 223.1.17 is 11011111 00000001 00010001 00000000

Given that, subnet 1 has 63 interfaces. To represent 63 interfaces, we need 6 bits (64 = 26)

So its addresses can be from 223.1.17.0/26 to 223.1.17.62/26

Subnet 2 has 95 interfaces. 95 interfaces can be accommodated using 7 bits up to 127 host addresses can represented using 7 bits (127 = 27)

and hence, the addresses may be from 223.1.17.63/25 to 223.1.17.157/25

Subnet 3 has 16 interfaces. 4 bits are needed for 16 interfaces (16 = 24)

So the network addresses may range from 223.1.17.158/28 to 223.1.17.173/28

4 0
3 years ago
What are the correct answers to the following questions?
Lena [83]

Answer:

1. analog sound

2. digital sound

3. pixels

4.  local area network

5.bus

6. slots

Explanation:

4 0
2 years ago
West Point Bridge Designer | Does anyone know a way to make this bridge cost less?
e-lub [12.9K]
Make the zig zag part more spaced out
4 0
3 years ago
What are the advantages and disadvantages of using wireless communications? What are the advantages and disadvantages of using w
Nimfa-mama [501]

Answer:

<u>Advantages of wireless communication:-</u>

  • Flexibility in transferring the message through communication for which the sender and receiver can be in any place.
  • Speed of the communication is accurate and fast
  • Due to no wiring , the cost of the wireless communication is less.

<u>Disadvantages of wireless communication:-</u>

  • The security is less as the data can be accessed by unauthorized sources at times.
  • The setting up of wireless communication complex and expensive.

<u>Advantages of wired communication:-</u>

  • Simple configuration
  • Higher bandwidth is present in the cable
  • High reliability

<u>Disadvantages of wired communication:-</u>

  • Mobility is present for communication
  • Installation requires lot of time due to cabling
  • Requires extra devices for covering large areas for communication

Wireless communication is more preferable than wired communication in the conditions like communication connection that should face low damage and longer life which is not present in cable connection as they break or get disrupted.The flexibility of moving while communication is required by most people so, they use wireless communication .

8 0
3 years ago
Other questions:
  • How will a packet tracer environment be affected if a heater is added to a container named branch office and turned on?
    5·1 answer
  • Trish uas bought a new computer, which she plans to start working on aftwr a week. Since Trish has not used computers in the pas
    13·1 answer
  • The manager of a sports club has data about the club members' ages in a workbook. He wants to find which age is most common. Whi
    13·2 answers
  • Exactly how thin is the air in outer space?
    10·1 answer
  • If you go over 255 in RGB by 1 does it reset to 0 or 1
    11·1 answer
  • You have a large TCP/IP network and want to keep a host's real time clock synchronized. What protocol should you use?
    10·1 answer
  • The average number of entities completed per unit time -- the output rate -- from a process is called ____.
    9·1 answer
  • ALSO PLZZZ HELP :P Suppose you are purchasing a game at a local retail store that comes on DVD. In order to install it on your l
    8·1 answer
  • An object completes one round of circle of radius 7m in 20 sec. Distance travelled after 10 sec is? ​
    12·1 answer
  • We call any device connected to the Internet a(n) ________. Group of answer choices router host IP client
    9·1 answer
Add answer
Login
Not registered? Fast signup
Signup
Login Signup
Ask question!