Question

1. It is a requirement to install a routing protocol that monitors the network for routers that have changed their link state. The __________ protocol provides the ability to accomplish this.
2. The __________ is a protocol that bases routing decisions on the network path and rules.
3. RIPv2 needs to be installed to enable dynamic routing. This should be installed in the __________ snap-in.
4. A customer requires a high-speed packet switching alternative to X.25. __________ should be installed.
5. X.25 connections utilize a clocking circuit. This makes them __________.
6. While analyzing Frame Relay frames, it is found that a message consisting of 10 separate packets was sent over five different circuits. These five circuits together form a __________ circuit.
7. A company just purchased a leased line that runs the Frame Relay service. The standard data rate for this service is known as __________.
8. A client wants to upgrade her remote users from dial-up to a faster service. However, cable Internet and DSL are not available in their respective areas. Another valid alternative is to use __________.
9. A customer wants a WAN technology that does not use variable-length packets but instead uses fixed-length cells. __________ is the recommended solution.
10. A client with eight computers needs a cost-effective Internet solution that can transmit 128 Kbps. __________ is the recommended solution.

Answer 1

Answer:

1. Open Shortest Path First (OSPF)

2. Border Gateway Protocol (BGP)

3. Routing and Remote Access Service (RRAS)

4. Frame relay

5. Synchronous

6. Virtual

7. Committed Information Rate (CIR)

8. Integrated Services Digital Network (ISDN)

9. Asynchronous Transfer Mode (ATM)

10. Basic Rate Interface (BRI).