If one load balancer fails, the secondary picks up the failure and becomes active. They have a heartbeat link between them that monitors status. If all load balancers fail (or are accidentally misconfigured), servers down-stream are knocked offline until the problem is resolved, or you manually route around them.

Explanation:

Load balancing is a technique of distributing your requests over a network when your server is maxing out the CPU or disk or database IO rate. The objective of load balancing is optimizing resource use and minimizing response time, thereby avoiding overburden of any one of the resources.

The goal of failover is the ability to continue the work of a particular network component or the whole server, by another, should the first one fail. Failover allows you to perform maintenance of individual servers or nodes, without any interruption of your services.

It is important to note that load balancing and failover systems may not be the same, but they go hand in hand in helping you achieve high availability.

3 0

2 years ago

Write a function named partfthat takes inas parameterstwo parallel lists: a list of times (in increasing order), and a list of d

mario62 [17]

The program calculates the velocity between points in a list is written below. The program is written in python 3 thus ;

t = input("Enter time values : ")

#Enter the time values of the data

p = input("Enter distance values : ")

#Enter the distance values

dist = [float(x) for x in p.split()]

time = [float(x) for x in t.split()]

#pyt then values in a list

def partfthat(dist, time):

#initialize function that takes in two parameters

vel = []

#empty list to hold the calculated velocity values

i = 0

#indexer

while i <= len(dist)-2:

#while loop to iterate

v = (dist[i+1] - dist[i]) / (time[i+1] -time[i])

#Use the velocity formula

vel.append(v)

#append values to the empty list created

i+=1

return vel

print(avg_vel(dist, time))

A sample run of the program is attached.

Learn more : brainly.com/question/25681441

4 0

2 years ago

Type the correct answer in the box. Spell all words correctly. What is the default margin width on all four sides of a document?

Sergeu [11.5K]

1 inch (2.54 cm

the default top and bottom margins were 1 inch (2.54 cm), but 1.25 inches (3.17 cm) were given at the left and the right.

That's standard for document size by default.

7 0

3 years ago