Answer:
IBM Automatic Sequence Controlled Calculator (ASCC)
Answer:
Question is incomplete. it needs a topology diagram and also it needs Router R1 table. I assume User has access to the topology and Routing table.
Below Configuration will help to fix ACL problem
Hosts from the 172.16.0.0/16 network should have full access to Server1, Server2 and Server3 but this is not currently the case, as L1 can’t communicate to Server2 or Server3.
Explanation:
Following Configuration on Cisco Router R1 will help to fix all the ACL problems.
enable
configure terminal
no ip access-list standard FROM_10
ip access-list standard FROM_10
deny host 10.0.0.2
permit any
exit
!
no ip access-list standard FROM_172
ip access-list standard FROM_172
permit host 172.16.0.2
exit
!
interface GigabitEthernet0/0
ip access-group FROM_192 out
end
write memory
!
Answer:
<u>He wants to easily and quickly find specific bits of research that cover certain topics.</u>
<u>Explanation:</u>
Remember, a research work typically has these 6 (six) components:
- The Abstract.
- Introduction
- Methodology
- Results
- Discussion
- References.
Thus, Aika's decision to label several folders for different parts of his research would make it easier and quicker for him to find specific bits of research that cover certain topics, instead of spending time looking for topics.
I've had that problem before. The cause of my problem was 2 things and that was the age of the cable, and build up of dust on each of the cable.
