Answer:
The answer to this question is given below in the explanation section.
Explanation:
This question is about to tell the best and suitable terms for the given descriptions in the question.
As we know that a computer program is based on sets of instructions. The CPU carries out the processing using the fetch decode and execute cycle.
It is responsible for implementing a sequence of instructions called a computer program that takes input, processes them, and outputs the result based on processing.
A CPU mainly has three components such as control unit, Arithmetic logic unit, and register.
The control unit controls all parts of the computer system. It manages the four basic operations of the Fetch Execute Cycle such as Fetch, Decode, Executes, and Storage.
So the correct terms of this question are:
Fetch: Gets next instruction
Decode: interprets the instruction
Execute: Carries out instruction.
Store: Save results of instruction.
Answer:
"Cross-training
" seems to be the right response.
Explanation:
- Cross-training seems to be the method of constructing a multi-professional workers staff with incentive plans to make sure that they must have the same tools to complete different occupational tasks throughout the organization.
- This will be a very broad approach besides randomized controlled training methods, both maximum and minimum frequency, for generations.
Answer:
The answer is "None of these".
Explanation:
In the given question an array "sales[]" is declared, which contains 50 double type elements, and in the next line, an integer variable j is defined, which uses a for loop. In this question two options is given, in which both are not correct, that can be described as follows:
- In option (i), A loop is defined that, uses variable j which starts with 0 and ends with 48, So total elements are 48 that's why it is not correct.
- In option (ii), A loop will use variable j that, starts with 1 and ends with 49, That's why it is not correct.
Answer:
Check the explanation
Explanation:
223.1.17/24 indicates that out of 32-bits of IP address 24 bits have been assigned as subnet part and 8 bits for host id.
The binary representation of 223.1.17 is 11011111 00000001 00010001 00000000
Given that, subnet 1 has 63 interfaces. To represent 63 interfaces, we need 6 bits (64 = 26)
So its addresses can be from 223.1.17.0/26 to 223.1.17.62/26
Subnet 2 has 95 interfaces. 95 interfaces can be accommodated using 7 bits up to 127 host addresses can represented using 7 bits (127 = 27)
and hence, the addresses may be from 223.1.17.63/25 to 223.1.17.157/25
Subnet 3 has 16 interfaces. 4 bits are needed for 16 interfaces (16 = 24)
So the network addresses may range from 223.1.17.158/28 to 223.1.17.173/28
Answer:
It prints "goodbye" 8 times.
Explanation:
The loop being described in this scenario would print "goodbye" 8 times. It would not include numbers detailing the range since the loop instructions only state for the system to print("goodbye") and nothing else. Also, it would only print it 8 times because in a range the endpoint is not included, this is mainly because in programming data structures tend to run on 0-based indexing.
