Answer:
enable the used ports in the router with their respective IP address and only the connected ports in the switch. Allow configure the STP on the switch
Explanation:
Network switches are used to connect a group of computer devices in a network LAN. It is automatically enabled when a port is connected and creates a MAC address table of the computers connected to it. STP or spanning-tree protocol is a protocol used to prevent looping in a switch. Unused ports can be disabled for security reasons.
A router is a network device that is used to forward packets between networks. All used ports in a router must be enabled and configured with an IP address and subnet mask.
When forced distribution is used to reduce leniency bias, this can cause <decreased trust> between employees if a pfp system is in place.
Answer:
# create the file
filename = "Testfile.txt"
# for writing, we create the output file:
outPutfile = open(filename, "w")
# Writing numbers from 1-100
for item in range(1,101):
outPutfile.write((str)(item))
outPutfile.close()
# printing the contents to verify it worked correctly
infile = open(filename, "r") #note the "r" indicates the mode
fileContents = infile.read()
infile.close()
print(fileContents)
Explanation:
- Define the working file fileName = TestFile
- Create the output file for writting outPutfile = open(filename, "w")
- Use a for loop to write numbers from 1-100 to the file outPutfile.write((str)(item))
- Close the file outPutfile.close()
- You may open the file read its content and print the contents to verify it worked correctly
Coding works through programming/programs. Programs have different coding languages, and text files. The code within the file is known as the "source CODE" this code is used in different ways, causing for the possibility of separate binary files that computers can directly run. Hope I helped.
An application used to access and view websites
