Answer:
The answer is "using validation error".
Explanation:
The validation error is used to response the test for one of the queries is activated to the participant, which may not properly answer the question. These errors go up continuously after each time, the processing rate is too high and also the method is different.
- These errors are also unless to increase when they are actually in the problem.
- The training level will be that, if the learning error may not increase when the model overrides the learning set and you should stop practicing.
Answer: Detailed
Explanation:
SDLC consist of 7 phases. They are:
1. Planning.
2. System analysis and requirement
3. Design:
4. Coding:
5. Testing:
6. Installation
7. Maintenance
Here we are talking of the third phase. In this phase it is the design phase which consist of high and low level design. Here the preliminary design is included in high level design where it describes the required hardware, software, network capabilities and the modelling of the interface. However the detailed design in low level design will implement the coding and will finding of any errors in the implemented design as described by the preliminary design.
the answer to the question is a Embedded ( I just learned this like a month ago so im pretty sure it right :))
Answer:
the subject of the message
the sender's name
the recipient's name
the date and time when the message was received
Explanation:
Various information is displayed in the header of the message of a received message. And they are the subject of the message, which briefs what is there inside the message. And it mentions the sender's name as well as the recipient's name, and finally, the date and the time as well are stated that explains exactly when the message was being received. And all this information is shown in the header of the message.
