import random
i = 1
while i <= 100:
print("#"+str(i)+": "+str(random.randint(1,100)), end=", ")
i+=1
print()
i = 1
while i <= 100:
print("#"+str(i)+": "+str(random.uniform(1,100)), end=", ")
i += 1
I hope this helps!
Spatial representation allows information to be viewed at a glance without needing to address the individual elements of the information separately or analytically.
<h3>What do you mean information?</h3>
- Information is a stimulus with meaning for the receiver in a specific situation.
- Data is a broad term that refers to information that is entered into and stored in a computer.
- Data that has been processed, such as formatting and printing, can be interpreted as information again.
- When you communicate verbally, nonverbally, graphically, or in writing, you are passing on knowledge gained through research, instruction, investigation, or reading the news.
- Information is known by many different names, including intelligence, message, data, signal, and fact.
- Information helps to avoid study duplication. Information stimulates the cognitive processes of users, particularly scholars.
- Scientists, engineers, academics, and others benefit from the use of information.
To learn more about Information, refer to:
brainly.com/question/4231278
#SPJ4
Answer:
Explanation:
The following code is written in Python. It asks the user to enter the current balance and the annual interest rate. It then calculates the monthly interest rate and uses that to detect the interest that will be earned for the next month. Finally, printing that to the screen. A test output can be seen in the attached picture below.
balance = int(input("Enter current Balance: "))
interest = int(input("Enter current annual interest %: "))
interest = (interest / 12) / 100
next_month_interest = balance * interest
print('$ ' + str(next_month_interest))
I prefer to choose the technician A. It should read approximately 12.6V. Volts is the basic unit used to measure voltage and I think the technician B stating the mv units in her reading comes from the units of his multitesters setting.
I would think the answer is C. Hope this helps! :D
