Answer:
Step-by-step explanation:
To complete the square, we first have to get our equation into 
form.
First we add 16x to both sides:
And now we subtract 62 from both sides.
We now have to add 
to both sides of the equation. b is 16, so this value becomes 
.
We can now write the left side of the equation as a perfect square. We know that x+8 will be the solution because 
and 
.
We can now take the square root of both sides.
We can now isolate x on one side by subtracting 8 from both sides.
So our solutions are
Hope this helped!
Answer:
2.) 145°
4.) 50°
Step-by-step explanation:
2.) First find the measure of Angle Y, since they are supplementary;
∠Z + ∠Y = 180
35 + ∠Y = 180
∠Y = 180 - 35
∠Y = 145°
So ∠X would be 145° as well
4.) First find the measure of Angle F, since they are supplementary;
∠C + ∠F = 180
130 + ∠F = 180
∠F = 180 -130
∠F = 50°
So ∠E would be 50°
(I didn't explain it much in detail, since this question is similar to the previous that i answered :)
Hope this helps!
Answer:
H affects horizontal shift (shift to the right or left) means moves graph right or left
Step-by-step explanation:
Answer:
see below
Step-by-step explanation:
A protractor is usually a transparent measuring device laid intended to be laid over an angle to be measured. The centerpoint of the protractor's scale is made to coincide with the angle's vertex, and the baseline of the protractor is aligned with one of the angle's rays. The appropriate scale is used to read the angle where the other ray crosses the scale. You usually have to visually determine if the angle is acute or obtuse, so you can choose the correct scale to read.
__
If you're drawing an angle, first draw one ray and locate the vertex on it. Then do the steps above as you would for measurement. Make a mark on your paper corresponding to the desired angle measure, and connect the vertex to that mark to create the other ray of the angle.
__
If you're working with a printed protractor, you may need to do your work on a piece of translucent paper or transparency material, so you can see the protractor scale through the page you're drawing on.
_____
<em>Comment on a printed protractor</em>
A protractor will only give accurate measurements if its geometry is perfect. Some printers will scale a figure differently in horizontal and vertical directions, so will make the protractor scale be elliptical instead of circular. That will give wrong readings.
