B, C, D, E, G are all parts of a financial plan.
A River Oaks Pools is trying to calculate the perimeter of the pool so they will know how many bricks to buy for the deck of the pool. Each square on the grid represents a square that is 3ft x 3ft. What is the perimeter of the pool?
Solution:
On the first row and last row, there are 7 numbers of squares. And on the 2nd to 5th row, there are 11 number of squares.
In getting for the perimeter of the area, we'll have to divide the regions.
Dividing the regions, we'll get three figures/planes :
2 rectangles with Length = 3ft x 4 number of squares and Width = 3ft x 2 number of squares
Thus, for the 2 rectangles,
Perimeter = 2(2L+2W) (times two since there are 2 rectangles)
Perimeter = 2(2(12)+2(6))
Perimeter = 72 ft
Another figure was formed is a square with a 21ft x 21ft
Perimeter = 4(21ft)
Perimeter = 84 ft
Add the two equivalent perimeters:
Total Perimeter = 72+84
Total Perimeter = 156 ft
Answer:
Physical characteristics.
Explanation:
She knew what type of birds they were based on their physical characteristics.
She didn't see their nests, or see them eat, and she didn't test and analyze their genetics, so a is the correct option.
Answer:
Technician A
Explanation:
While technician B is only partially correct, the statement of the technician A is completely true. Most shops use a spray wash cabinet, which is similar to a dishwasher that contains a strong soap and hot water solution. The solution is sprayed at parts, that are placed on a turntable, under high pressure, successfully removing oil, grease, and dirt.
As the technician B stated, some shops dip major engine parts in a hot caustic solution (but not a cold one). This method is called hot tanking, and although it cleans the engine parts well, it rarely removes all of the rust and oil paint. Due to environmental issues, this method is being used less and less.
<span>A reverse fault is caused by compression and tension. The layers of rock in a reverse fault are compressed until finally the tension causes part of the plate to shift and crack into an upward movement. This creates a fault line placing one part of the layer higher than the other part of the layer. The answer would be A, compression creates upward vertical movement.</span>