Answer:
The microorganisms present metabolic wastes that serve as the primary source of food for other living things.
Bacteria that live free in the soil or in symbiosis with plants are essential to fix nitrogen, both nitrates and ammonia. These bacteria take nitrogen directly from the air, originating compounds that can be incorporated into the composition of the soil or living beings.
This property is restricted only to prokaryotes and is widely distributed among different groups of bacteria and some archaeobacteria. It is a process that consumes a lot of energy that occurs with the mediation of the enzyme nitrogenase, which the rest of the living organisms that cannot do or comply with this process is because they lack said enzyme.
Dunaliella is a genus of microscopic algae of the Chlorophyceae class and of the order Volvocales. All are unicellular, although with very varied morphologies.
Morphologically, its main characteristic is that they lack a rigid polysaccharide cell wall.
The ecology of this genus of green algae is characterized by its high tolerance to salinity, with eukaryotic organisms having greater tolerance to salt. They are euryhaline, adapted to salt concentrations from 50 mM NaCl to almost 5.5 M NaCl.
Explanation:
By nitrogen fixation is meant the combination of molecular nitrogen or dinitrogen with oxygen or hydrogen to give oxides or ammonia that can be incorporated into the biosphere. Molecular nitrogen, which is the majority component of the atmosphere, is inert and not directly usable by most living things. Nitrogen fixation can occur abiotic (without the intervention of living beings) or by the action of microorganisms (biological nitrogen fixation). Fixation in general involves the incorporation into the biosphere of a significant amount of nitrogen, which globally can reach about 250 million tons per year, of which 150 correspond to biological fixation.
Sound quality can be divided into amplitude, timbre and pitch. If there’s an impedance mismatch between your two devices connected to the single output, you could have a large mismatch between the levels arriving at each device. If the difference is large enough, one device may have distorted or inaudible audio.
To avoid this, you should ensure that both devices connected to the split signal are similar - such as 2 pairs of headphones, 2 recorder inputs, and so on. When you place 2 devices with wildly differing load impedances on a splitter is when you’ll encounter problems - such as headphones on one split and a guitar amp input on the other.
To get around this, you can use either a distribution amplifier (D.A.) or a transformer balanced/isolated splitter - which will work over a larger range of load impedances, typically. Depends on the quality of the splitter and the exact signal path. If you’re using the splitter to hook two things into one input, and you’re using quality connectors, you probably won’t lose much quality. There can be an increase in impedance of the cable due to the imperfect continuity of the physical connection, however with unbalanced line-level signals, impedance at both ends of the chain tends to be orders of magnitude higher than the connection will create, so one split will be barely noticeable. So too, the noise increase from the additional length of cable.
Now, one source into two inputs, that will by basic math and physics result in a 3dB drop in signal strength, which will reduce SNR by about that much. By splitting the signal path between two inputs of equal impedance, half of the wattage is being consumed by one input and half by the other (the equation changes if the inputs have significantly different impedances). So each input gets half the wattage produced by the source to drive the signal on the input cable, and in decibel terms a halving of power is a 3dB reduction. Significant, until you just turn the gain back up. The “noise floor” will be raised by however much noise is inherent in the signal path between the split and the output of the gain stage; for pro audio this is usually infinitesimal, but consumer audio can have some really noisy electronics, both for lower cost and because you’re not expected to be “re-amping” signals several times between the source and output.
The algae in the ocean have a very high Net Primary Productivity (NPP) and a very low amount of store biomass. This is because THE GROWTH RATE OF ALGAE IN THE OCEAN IS HIGH. The store biomass is low because THE PRIMARY CONSUMERS FEED ON THESE ALGAE THUS LOWERING THE BIOMASS AMOUNT. The production of biomass is related to the NPP.
Answer:
0.058 % kcalories comes from carbohydrate.
Explanation:
1 g of carbohydrtes gives 4 calories, 1 g of protein gives 4 kcalories, 1 gm of fat gives 9 calories and 1 g of alcohol gives 7 calories of energy.
Thus in a meal that contains 110 g carbohydrates gives 110 x 4 = 440 calories, 25 g protein gives 25 x 4 = 100 calories, 20 g fat gives 20 x 9 = 180 calories and 5 g alcohol gives 5 x 7 = 35 calories.
Total calories in a meal 440+100+180+35 = 755.
Therefore % of carbogydrate will be 440x 100 divided by 755 = 58.27 %
In kcalories % would be 58.27/1000 = 0.5827 %
B. the same number of chromosomes as the parent cell. - as a result of mitosis.