The statement which best explains how algorithms running on a computer can be used to solve problems is; D. Some problems cannot be solved by an algorithm.
<h3>What is an algorithm?</h3>
An algorithm is simply a standard formula or procedures which is made up of a set of finite steps and instructions that must be executed on a computer, so as to proffer solutions to a problem or solve a problem under appropriate conditions.
However, it should be noted that it is not all problems that can be solved by an algorithm, especially because the required parameters and appropriate conditions are not feasible or met.
Read more on algorithm here: brainly.com/question/24793921
Answer:
I think you have to restart your device.
Answer:
Answer below
Explanation:
Maximum transmission unit (MTU)
A maximum transmission unit (MTU) is the largest packet or frame size that is usually specified in Eight-bit bytes, which can be sent in a packet or frame-based network such as the internet.
Longest Prefix Match
Longest prefix match is an algorithm used by routers in Internet Protocol to lookup the IP prefix that will likely be the terminal point of the next hop from the router.
CIDR and Subnet Mask
CIDR, known in full as Classless inter-domain routing, is a set of IP standards that is used to make customized identifiers for networks and individual devices.
A subnet mask separates the internet protocol (IP) address into the network address and host address.
Switching Fabric
Switching fabric is simply an arrangement of the elements of a communication network also known as network topology, whereby the nodes of the network are seen to interconnect with one or more network switches.
Answer:
The code to this question can be given as:
code:
tp = ip;
ip = jp;
jp = tp;
Explanation:
In this question, it is defined that write code for swapping values that swap the pointers, not the values they point to. So in this code, we assume that all the variable and its value is defined. we simply use the swapping rule that is the first value holds in the new variable and second value hold on the first variable and in the last second variable holds the value of the new variable. In this code, the value will be interchanged or swapped.
