Answer:
to understand the human and animal behaviour
Explanation:
By looking at the biological bases of human behavior, psychologists are better able to understand how the brain and physiological processes might influence the way people think, act, and feel.
Answer:
Ss (male) × Ss (female)
Explanation:
This question involves a single gene coding for hair length in guinea pigs. Based on the information in this question, the allele for short hair (S) is dominant over the allele for long hair (s). This means that a guinea pig will only be phenotypically long-haired if the genotype is "ss".
According to this question, Two short-haired guinea pigs are mated several times. Out of the 100 offsprings produced by this cross, 25 of them have long hair (recessive). This means that the phenotypic ratio of this cross is 3 short hair : 1 long hair i.e. 100 - 25 = 75 short hair. 75/25 = 3/1 = 3:1
To produce this phenotypic ratio, the parents must both be heterozygous (Ss) for the hair length gene.
1. Hydropower
2. Solar
3. Coal
4. Oil
5. Biomass
Answer:
External factors include physical and chemical signals. Growth factors are proteins that stimulate cell division. – Most mammal cells form a single layer in a culture dish and stop dividing once they touch other cells.
Explanation:
From Google
Explanation:
Wind energy, or wind power, is created using a wind turbine, a device that channels the power of the wind to generate electricity. The wind blows the blades of the turbine, which are attached to a rotor. The rotor then spins a generator to create electricity . Wind energy is a renewable energy source that is clean and has very few environmental challenges. Wind power actually starts with the Sun. In order for the wind to blow, the Sun first heats up a section of land along with the air above it. That hot air rises since a given volume of hot air is lighter than the same volume of cold air. Cooler air then rushes in to fill the void left by that hot air and voila: a gust of wind. The Office of Energy Efficiency and Renewable Energy describes a wind turbine as “the opposite of a fan.” Simply stated, the turbine takes the energy in that wind and converts it into electricity. So how does it do that? First, the wind applies pressure on the long slender blades, usually 2 or 3 of them, causing them to spin, much like the wind pushes a sailboat along its path through the water. The spinning blades then cause the rotor, or the conical cap on the turbine, and an internal shaft to spin as well at somewhere around 30 – 60 revolutions per minute. The ultimate goal is to spin an assembly of magnets in a generator which will, well, generate voltage in a coil of wire thanks to electromagnetic induction. Generators require faster revolutions, however, so a gear box typically connects this lower speed shaft to a higher speed shaft by increasing the spin rate to around 1000 to 1800 revolutions per minute. These gear boxes are costly as well as heavy, so engineers are looking to design more “direct-drive” generators that can work at the lower speeds.
