Bsbsnsnsnsn jajwjemoeododhdhdw whajsjshtzzvsssnxbba. 3
Answer:
Check the explanation
Explanation:
A packet filter firewall is used as a check point between internal corporate network to the outside internet. It blocks all the inbound traffic from the outside hosts trying to initiate a direct TCP connection to the internal corporate webserver. The network design with firewall is shown in the attached image below:
The figures in the attached image below shows an internal corporate network is protected with a packet filter firewall to minimize the inbound traffic from the external network or an internet. Therefore, the packet filter is used as a check point between the network.
The packet filter blocks all attempts by the outside hosts in order to initiate a direct TCP connection to the internal webserver of the internal corporate network.
Going by the second part of the attached image below can can therefore conclude that:
• Rule 1 specifies that, deny any packet with the destination address 5.6.7.8 if the STN flag of TCP header is set.
• Rule 2 specifies that, allow the inbound email traffic from the external source.
• Rule 3 specifies, allows the Outbound TCP traffic from the internal corporate network.
• Rule 4 specifies, allows outbound Email traffic from the internal corporate network to the external network.
• Rule 5 specifies, block any traffic from any source to the any destination.
yes i do....................................................
Answer:
B. Click Set Up, Slide Show, and then select the Loop continously until 'Esc' and use timings, if present options.
Explanation:
PowerPoint presentation is a program which was developed by Microsoft. It is a platform which is used to create business presentation or educational presentations, etc.
In order to play the slide show continuously without our interaction, we need to do the following steps :
1. In the powerpoint presentation, we have to click "Slide Show" tab in the ribbon and then click on the "Set up slide show" on the Set Up bar.
2. The set up slide show dialogue box will pop up. In this we have to check or tick on the "Loop continuously until 'Esc' " in the "Show Option" and then click 'OK'
3. Now in the "Slides" preview side panel, we have to click the 1st slide , then Press and hold the 'Shift' key and then click the last slide. This selects all the slides.
4. Now, in the transition tab, in the "Timing" group, we have or uncheck or untick the " On Mouse Click " and also check the " After"