Answer:
One sheave means that you are using a single drum winder. They are the worst! Double drum winders control easier, brake better and are much more efficient. They save time ( two skips or cages) and can be clutched to perform faster shift transport. A single drum is slow, unbalanced and can be a nightmare if it trips out during hoisting. If the brake system is not perfect it can be a real hairy experience. For a runaway single drum, there is no counterbalance effect. It always runs to destruction. With a double drum, the driver still has a chance to control the winder to a certain extent and he has two sets of brakes to rely on. A single sheave could also mean a shaft with a single compartment. No second means of escape unless there are ladders or stairways. Not a very healthy situation.
Those are just a few points. I am sure much more can be said in favor of a double drum winder and two or more sheaves in the headgear. Most of the shafts I have worked at have multiple winders and up to ten compartments. They all have a small single drum service winder for emergencies and moves of personnel during shift times. They are referred to as the Mary - Annes. Apparently, the name originated in the U.K. where an aristocratic mine owner named the first such winder after his mistress.
Explanation:
<em>Hope you got it </em>
<em>If you have any question just ask me</em>
<em>If you think this is the best answer please mark me as BRAINLIEST</em>
Assigning values at run time
Assigning values as command line argument, before execution of the program
The issue would be that the memory was not installed or was not detected by the system. If this happens, the system boot will fail and a beep code is heard. The system would not show anything since all of the software are in the memory which was not installed or detected.
This is the correct Answer <span>Attribute</span>
